This paper presents the results of 159 finite element simulations conducted to define the effects of excavation geometry, i.e., length, width and depth of excavation, wall system stiffness, and factor of safety against basal heave on the 3-dimensional ground movements caused by excavation through clays. The results of the analyses...
Several three-dimensional effects were observed in the performance monitoring data collected during excavation for the Ford Engineering Design Center (FEDC) in Evanston, Illinois. These responses are related to lateral deformations of the soil around the excavation walls, forces in the cross-lot and diagonal bracing that supported the temporary wall and...
An empirical procedure for fitting a complementary error function (erfc) to settlement and lateral ground movement data in a direction parallel to an excavation support wall is proposed based on extensive optical survey data obtained around a 12.8 m excavation in Chicago. The maximum ground movement and the height and...
Non-destructive evaluation (NDE) techniques have been used for a number of years to provide quality control of construction procedures for drilled shafts and driven concrete piles. In particular sonic echo and impulse response methods have been used extensively to check lengths and continuity of newly-installed foundations. In recent years, the...
This presentation provides information on the progress report of the project "Empirical Study of Life-Cycle Cost Analysis for Bridges" by Ahmad Hadavi, 2003.
A study is conducted to determine the effects on the early hydration kinetics and
compressive strength by seeding of Portland cement and alkali-activated blast furnace
slag with a pure form of calcium silicate hydrate (C-S-H). The effects of C-S-H seeding
during the early nucleation and growth period of each type...
The objective of this program is to measure the changes in the properties of the C-S-H gel phase in cement paste as a function of the Ca/Si ratio. The motivation is to better understand the hydration products that form in blended cements with lower Ca/Si ratios than portland cement. The...
This presentation provides information on the project "Safety Concrete - a Material Designed to Fail" by Jeffrey J. Thomas, Julie Gevrenov, Hamlin Jennings, and Edward O'Neil. The presentation was delivered at the 106th Annual Meeting & Exposition of The American Ceramic Society, Indianapolis, Indiana in 2004.
This presentation contains information about the project "The future of transportation... and how we'll pay for it" by Joseph L. Schofer, Department f Civil & Environmental Engineering. The presentation was delivered at the 40th Anniversary Seminar Day at Northwestern University on April 18, 2009.
This presentation contains information on the project "Aligning Data to Support Transportation Decisions, Emerging Challenges & Opportunities for the Data World". The presentation was delivered by Joseph L. Schofer at Transportation Research Board – AASHTO Peer Exchange meeting on May 15-16, 2008.