A study is conducted to determine the effects on the early hydration kinetics and
compressive strength by seeding of Portland cement and alkali-activated blast furnace
slag with a pure form of calcium silicate hydrate (C-S-H). The effects of C-S-H seeding
during the early nucleation and growth period of each type...
The segmental prestressed concrete box girder of Koror-Babeldaob (KB) Bridge in Palau, which had the record span of 241 m (791 ft.), presents a striking paradigm of serviceability loss due to excessive multi-decade deflections. The data required for analysis have recently been released and are here exploited to show how...
The in-depth inspection by WIDOT detected two sites that had visible cracks in the stiffener-to-hanger diaphragm welds, the east side of Hanger 6 in the north tie girder, and the east side of Hanger 4 in the south tie girder. Additionally, many ultrasonic indications were detected by WIDOT in the...
The U.S. has 542,000 bridges that consume billions of dollars per year in construction, rehabilitation and maintenance funds and which are the lifelines of U.S. commerce. The 1992 ISTEA (fntermodal Surface Transportation Efficiency Act) mandates the implementation of a quantitative computerized bridge management system by I 996. A prime need...
The objective of this program is to measure the changes in the properties of the C-S-H gel phase in cement paste as a function of the Ca/Si ratio. The motivation is to better understand the hydration products that form in blended cements with lower Ca/Si ratios than portland cement. The...
Non-destructive evaluation (NDE) techniques have been used for a number of years to provide quality control of construction procedures for drilled shafts and driven concrete piles. In particular sonic echo and impulse response methods have been used extensively to check lengths and continuity of newly-installed foundations. In recent years, the...
During the past several years an easily weldable, high strength (more than 75 ksi yield), high impact fracture toughness steel (NUCu steel) has been investigated at Northwestern University with bridge applications in mind. For good weldability without pre-heating and post-heating, the carbon content of the steel was kept low and...
Northwestern University developed copper-precipitation-hardened, high-performance weathering steel (NUCu 70W Steel) that is produced by hot rolling after casting and then air-cooling. Due to simple processing the steel is fabricated at lower cost than competing high-performance steels that require quench and tempering. NUCu 70W steel can be easily welded without pre-...
Construction is omnipresent in modern-day America. It's the sound and vibration of a nation scrambling to keep up with its burgeoning population. In most states, allowable construction-induced ground motions range from 0.5 to 1.0 inches per second (in/sec) and under certain
conditions up to 2.0 in/sec.
However, ground motion as...