Several three-dimensional effects were observed in the performance monitoring data collected during excavation for the Ford Engineering Design Center (FEDC) in Evanston, Illinois. These responses are related to lateral deformations of the soil around the excavation walls, forces in the cross-lot and diagonal bracing that supported the temporary wall and...
This paper presents the results of 159 finite element simulations conducted to define the effects of excavation geometry, i.e., length, width and depth of excavation, wall system stiffness, and factor of safety against basal heave on the 3-dimensional ground movements caused by excavation through clays. The results of the analyses...
Successful use of monitoring data to update performance predictions of supported excavations depends equally on reasonable numerical simulations of performance, the type of monitoring data used as observations, and the inverse analysis techniques used to minimize the difference between predictions and observed performance. This paper summarizes each of these factors...
Two numerical procedures are described that quantitatively identify a set of constitutive parameters that best represents observed ground movement data associated with a deep excavations in urban environments. This inverse problem is solved by minimizing an objective (or error) function of the weighted least-squares type that contains the difference between...
This paper describes developments of integrated tools for predicting, monitoring, and controlling ground movements associated with excavations in urban areas. Successful use of monitoring data to update performance predictions of supported excavations depends equally on reasonable numerical simulations of performance, the type of monitoring data used as observations, and the...
This presentation provides information on the the project "Use Of High-Performance A710 Grade B Steel in Construction of Lake Villa, IL Bridge". The presentation was delivered by Morris E. Fine, Semyon Vaynman, and Nunzio Mario Biondolillo on June 14, 2006.
During the past several years an easily weldable, high strength (more than 75 ksi yield), high impact fracture toughness steel (NUCu steel) has been investigated at Northwestern University with bridge applications in mind. For good weldability without pre-heating and post-heating, the carbon content of the steel was kept low and...
Northwestern University developed copper-precipitation-hardened, high-performance weathering steel (NUCu 70W Steel) that is produced by hot rolling after casting and then air-cooling. Due to simple processing the steel is fabricated at lower cost than competing high-performance steels that require quench and tempering. NUCu 70W steel can be easily welded without pre-...
This thesis combines field and laboratory measurements with three dimensional (3D) finite element analysis (FEM) to demonstrate the use of Time Domain Reflectometry (TDR) cable-grout composites to measure localized shearing in soft soil. Past field installations of TDR cable-grout composites in rock have lead to its widespread use in the...