Few would argue that concrete is an important and useful material: after all, concrete is the backbone of the world’s infrastructure, used in vast amounts to make roads, buildings, bridges, and other structures. But sometimes familiarity breeds contempt. To most people, concrete is simply that boring grey stuff that we...
The objective of this program is to measure the changes in the properties of the C-S-H gel phase in cement paste as a function of the Ca/Si ratio. The motivation is to better understand the hydration products that form in blended cements with lower Ca/Si ratios than portland cement. The...
This final report provides information about TEA-21 [Transportation Equity Act for the 21st Century] funded projects designated A433, and A495 "Evaluation of Capacity of Micropiles Embedded in Dolomite". The report was submitted to the Infrastructure Technology Institute at Northwestern University by Richard J. Finno on September 20, 2002.
Non-destructive evaluation (NDE) techniques have been used for a number of years to provide quality control of construction procedures for drilled shafts and driven concrete piles. In particular sonic echo and impulse response methods have been used extensively to check lengths and continuity of newly-installed foundations. In recent years, the...
This final report contains information on years 6-7-8 (2004-2007) of TEA-21 funded projects designated A487, W420, and A212. The report was submitted by Morris E. Fine and Semyon Vaynman in 2007.
During the past several years an easily weldable, high strength (more than 75 ksi yield), high impact fracture toughness steel (NUCu steel) has been investigated at Northwestern University with bridge applications in mind. For good weldability without pre-heating and post-heating, the carbon content of the steel was kept low and...
Northwestern University developed copper-precipitation-hardened, high-performance weathering steel (NUCu 70W Steel) that is produced by hot rolling after casting and then air-cooling. Due to simple processing the steel is fabricated at lower cost than competing high-performance steels that require quench and tempering. NUCu 70W steel can be easily welded without pre-...
Northwestern University developed copper-precipitation-hardened, high-performance weathering steel (NUCu 70W Steel) that is produced by hot rolling after casting and then air-cooling. Due to simple processing the steel is fabricated at lower cost than competing high-performance steels that require quench and tempering. NUCu 70W steel can be easily welded without pre-...